Find out how to Exchange the Lid Swap on a Whirlpool Washer

So, you’ve got returned to the laundry room with a washer sitting idle and filled with moist clothes. One of the crucial frequent causes of a direct drive washer that doesn’t spin is a defective lid swap. This can be a frequent restore for Whirlpool, Kitchen-aid, Kenmore and Roper top-load washers. Comply with these steps and your washer might be again to draining very quickly whirlpool washer repair los angeles.

To confirm if the lid swap is damaged, gently decrease the lid and you need to hear a click on when the lid actuator contacts the lid swap. Additionally, a multi-meter can be utilized to check a lid swap however you’ll need to achieve entry to the inside of the washer.

First, unplug the washer earlier than you start any restore. Subsequent, you’ll have to take away the console however there are a number of methods to do that relying in your mannequin washer. The commonest method is to take away the tip caps from either side of the console. That is finished by firmly pulling ahead on the prime of the tip cap till it snaps free. You’ll then see one screw on either side of the console that can must be eliminated. With screws eliminated, pull ahead and flip up the entire console gently and let it relaxation backwards. Subsequent, unplug the lid swap connector harness.

Now you should utilize your multi-meter to test the lid swap for continuity with the lid resting within the closed place. If the swap is defective, the cupboard will be eliminated to achieve entry to it for alternative.

With the console up and utilizing a screwdriver, the spring clips on either side of the highest cupboard will be eliminated. Gently pop the clips out and set them apart. Subsequent, attain in with one hand grabbing the cupboard whereas the opposite holds the lid open and pull the cupboard ahead.

Carry the cupboard’s lid and you will note that the lid swap is held in place with two screws. Take away these screws with a Phillips-head screwdriver and in addition take away the bottom screw connected to the cupboard. Push the grey tube holding the wires out of the clip that holds it and launch the plug from the slot within the prime of the cupboard.

Reinstall the brand new lid swap by securing it to the washer with the 2 retaining screws. Place the wire meeting again beneath the within fringe of the cupboard and insert the brand new swap connector into the slot within the prime of the cupboard.

The cupboard will be reinstalled by guiding the entrance decrease a part of the cupboard underneath the washer assist body first, after which letting the cupboard set backwards. There are locking tabs on the washer’s backside body that the cupboard will fall into. It might take a number of tries to place the cupboard appropriately so be affected person. After the cupboard is again in place, reattach the highest cupboard clips by pushing them firmly into the cupboard slots. Lastly, the wiring harness for the lid swap will be reattached and the console secured with the 2 retaining screws.

Leave a Reply

Your email address will not be published. Required fields are marked *